P1P Wyze Cam v3 Internal Mount

I wanted to mount one of my Wyze Cam v3s inside of my p1p so I could watch it remotely. I took apart one of the wyze v3 cams and if you strip the case and speaker out of it, it's about 2/3rds as thick - just the right size to fit in the P1P if you're careful.

See pictures for where and how to mount this in the P1P. Note: The model isn't perfect - and required a bit of tweaking after I printed it (the 5th time!). It prints with the face on the build plate and there is a 1mm thick part that supports the back that you need to trim after the print. Note, it does require supports to be enabled, but if you print it on it's face, they are fairly minimal.

Also: If your p1p is not enclosed, you'll want to use a rubber band to keep the camera attached to the bracket (or some other method). As you can see in my pictures, I'm using the rear plastic panel to keep the camera in place.

To take apart one of the wyze cam v3s, see here. BE CAREFUL to remove the rubber stoppers and NOT PUSH THEM INSIDE. If you push the rubber stoppers into the camera, they are nearly impossible to get out and you will not be able to disassemble the camera nondestructively.