P1P Pi Camera Mount
Description
PDFA housing to mount the original Pi Camera module in the rear right corner of the Bambu Labs P1P.
The potato cam that comes with the P1P could do with an upgrade so this mount will allow you to install the PI Camera module and run MotionEye or similar on a Raspberry Pi for remote monitoring.
Version 1 Is not the most elegant solution as you will need to find 2 or 3 little M3 x 5mm self tapping screws to hold the camera in place and fix the mount to the P1P frame so it can survive the vibrations of sport mode.
There is no back cover because I got it working and installed, can't see that side of the camera from my desk and life got in the way.
Print with the red face shown in the picture to build plate, no supports needed. I think I did 0.2mm layers in PLA but will need something more heat resistant if using an enclosure.
Version 2 It seems I can't publish a half done project so I have redesigned it to have a back cover that holds the camera in place without needing screws.
The lugs have also been tweaked so that the screwing the housing to the frame is now optional too.
Model origin
The author marked this model as their own original creation.
