Motor mount for 3DLabprint Slingblade and Racestar 4108

Here is my design of a motor mount for the 3Dlabprint Slingblade.
With this motor mount you can install a Racestar 4108 in your Slingblade.
Propeller 9x6
6S / 1300 mAH LiPo
ESC 40 Amp
Very hot ;-))

There are two versions of the part. One version is for the new building, the other version for retrofitting on the original motor mount.

Print with at least 2 perimeters, 100% infill, layer height 0.2mm and support.

The engine is bolted from the inside. The screw holes must be installed horizontally so that you can screw them tight from the inside.

So have fun with it.

Print instructions

Category: R/C Vehicles Summary

Here is my design of a motor mount for the 3Dlabprint Slingblade.
With this motor mount you can install a Racestar 4108 in your Slingblade.
Propeller 9x6
6S / 1300 mAH LiPo
ESC 40 Amp
Very hot ;-))

There are two versions of the part. One version is for the new building, the other version for retrofitting on the original motor mount.

Print with at least 2 perimeters, 100% infill, layer height 0.2mm and support.

The engine is bolted from the inside. The screw holes must be installed horizontally so that you can screw them tight from the inside.

So have fun with it.

Print Settings

Printer Brand:

Prusa

Printer:

i3 MK3

</div>Rafts:

No

Supports:

Yes

</div>Resolution:

0,2

Infill:

100 %

</div>
Filament:
OWL Filament PETG Black