This is an organizer insert for the base set of the board game Sub Terra. It consists of several pieces to accommodate the various game pieces. My primary goals were to create something that allowed you to easily access all of the components of the game quickly upon opening the box, yet also keep them in place regardless of orientation of the box while stored. Lay the game box on its back, set it upright, or on its side. It should not matter, and the game pieces inside should stay in place. I did not necessarily design this with "no supports" or "use the least amount of filament possible" in mind.
Upon printing all of the pieces, putting them in the box, putting all of the components in their respective holders, putting the instruction book on top, and finally closing up the box everything should stay in place relatively well.
I made this particular design because it's likely I'll never buy any of the expansions, but I still wanted something to fit everything nicely.
The author marked this model as their own original creation.