Guide block numbers - Addon for USR - Universal Spool Rail

Addon for my USR - Universal Spool Rail. 

With this plate, the individual PTFE tubes can be identified directly on the guide block. For better readability, a strip of paper is used as background.

Print it with the numbers facing down, no support needed at all.

Assembly: 

• You need a paper strip with a width of about 12mm
• If necessary, clean the slot with a cutter knife
• Slide the paper strip through and cut accordingly
• The assembly will be easier if the strip is not so wide on one side on a length of about 10cm and then becomes wider. This allows you to push the strip through easier and then pull it on the other side.
• The plate should be able to be mounted on the guide block with gentle force and hold by itself

https://www.printables.com/model/470408