Case With Battery Door For GM328 Component Tester

This is a remix of https://www.thingiverse.com/thing:2775688

I wanted to be able to access the battery with one screw. I also wanted the device to be at an angle but not too steep so the test components don't fall out while working with it. I'm very happy with the results, and I hope others find it useful too.

Print Settings

Printer Brand:

Monoprice

Printer:

Rafts:

No

Supports:

Filament: Monoprice PLA

Notes:

I used #4 x 3/8" (3mm x 10mm) size sheet metal screws to fasten the PCB and #4 x 3/8" (3mm x 10mm) wood screw for the battery door.

I put small rubber feet on the bottom to keep it from sliding around.