Slingshot

A slingshot I designed. You will need a special rubber tubing made for slingshots as well as two metal beads. you put the rubber tubing through the two holes and then insert the metal balls inside the tubing to keep them in place. If under 18, please use adult supervision when playing.

If you liked this project, you can now support me by buying me a pizza :)! https://www.buymeacoffee.com/OBconcepts 

Print instructions

You will need supports and the higher the infill the better (USE MORE PERIMETERS). You can try printing it vertically without supports, but I have not tried it so if you do, let me know how it went. The layer height is not that important, as you will probably have to sand it down later on.

UPDATE (Version 2 Slingshot (white background)) (EASIER PRINT):

I have redesigned it in order to make printing a bit easier. However, for this version you will be required to get:

- 4 x M4 x 6mm socket head screws 

- 2 x M4 x 10mm hex extension/coupling nut (10mm in length, M4)

-Two allen keys for the M4 to screw it together potentially, but probably not required. 

- An allen key shackle (the typical small 5mm one), to finish the look of the slingshot and for easy attachment options. 

IMPORTANT! 
This version has not yet been tested and I do not know if the tolerances are correct, so please let me know if you do print it. I will make changes if needed.