Ender 3 Pro Vslot Cable Tie Clip

This was remixed from another model but for the life of me i cannot find the original Maker…. If anyone has a link please let me know so i can add credit to this mode.

So what is it?

The clip used to be missing a middle section on and it was a pain in the backside to feed a Zip/Cable tie through it if it was on the printer.

i remodelled and added 2 prongs to guide the zip/cable tie on (just make sure you know where way the prongs are going :P)

these clips are great but are very difficult to remove once you have put them on, they will slide across as needed but if you want to remove them a little force is required.

I have 4 of these on my printer and they have never let me down.

I printed mine at a  layer height of 0.15 and used a 20% infill (although I think any infill will be fine)