The Ultimate LED Strip Clip

I was looking for a good way to temporarily hang lights in my college dorm room in a non destructive way to the room or the light (not taking the adhesive strip off). I came up with these, they work for 10mm width lights (ex. WS2812B), both waterproof (thick silicone coating) and non-waterproof versions. This was designed to perfectly fit 60 pixel/m strips, but should work with other spacings as well. 

To attach them, there is a countersunk hole for screws, or you can do what i did and just put double sided tape on the back for easy removal later. The clap for the clips in also removable so you can quickly pop them off and take the strip down leaving the main body of the wall for ‘surprise dorm room inspections’. Then you can easily put them back up and click them in place.  

I hope you find these useful, if you find anything that can be improved, make a comment and I'll try my best to correct it. Enjoy!

RECOMMENDED PRINT SETTINGS:

• Layer height ≤0.15
• Width ≤0.45
• Infill ≥20%
• Supports: None
• Print clasp on it's side