Print in Place Noisemaker

The classical wooden noisemakers, now in a simple, print-in-place design!  After a quick print, and easy post-processing, you'll have a delightful little noisemaker.  Great for parties, parades, and anywhere else that needs a little noise.

Printing Tips:

- Print in a hard filament (PLA, PETG, etc.)

- NO SUPPORTS

- Double check slicer to make sure parts do not overlap and have gaps between layers

- Print with the large base flat to the build plate, with the handle upright

- For best results, ensure thin vibrating section is two print widths (continuous down and back on printer)

Examples were printed with the following settings:

- Printed in PETG (235°C nozzle, 70°C bed)

- 0.2mm Layer Height

- 20% infill

- 70mm/s print speed

- Thin walls on

- No Supports

Post-Processing Tips:

- Give firm twist to separate parts if they are not loose

- Slowly twist handle back and forth to smooth surfaces between parts

- Use a small hobby knife to clean any small globs or strings

- Enjoy!