Wooden geometric planter

This is a big planter! I used 0,8mm nozzle with 0,4mm layer height for faster printing speed and to make the layer lines show better, but standard nozzle would probably work fine. 

Prints without supports, but lots of overhangs so slow speed or sufficient cooling is recommended. 

You can also adjust the z-height in slicer a bit to make the pattern and the whole pot wider/taller. Adjust your own height to your preference. 

If you encounter first layer issues, lower the whole model a tiny bit (0,2mm or so). 

Not watertight without some post processing. One thick layer of some kind of coating on the inside should do the job. 

Also check out my small geometric planter: https://www.printables.com/model/525969-small-modern-geometric-planter