It doesnt spread water enough and holes are big, so it doesn't provide much benefit.
There is no hole in back for getting air back. On my jug doesn't fit properly and pin, but thats just my problem probably
Milk Jug Watering Can!
Turn any milk jug into a convenient watering can!
97
648
6
1651
updated
April 12, 2026
Makes
Comments
Printed mine in PETG (no supports). Top of milk bottle has a small hole punched to allow water to flow.
Unfortunately here in Australia, the thread seems to be exactly 180 degrees from pouring via the bottle handle. I have to tighten past where the thread stops to get it to pour without leaking, which means I replace the bottle every week or two. (edited)
Does this need supports or no?
@ygoodwin_1876654 I would recommend supports.
Works great after poking a hole in the jug for air!
Printed using Overture Transparent PETG.
Works good but it needs a hole for air so the water comes out smoother.