Size C Ball Bearing Unresponsive Yoyo

An unresponsive yoyo that takes a standard size C bearing, 12mm axle and slim 19mm response pads. Smaller axle can be used with a thinner bearing.

I used a centre trac bearing, and aliexpress pads. 

Printed with 100% infil, 0.6 line width and 0.3mm layer height. Recommend using the “lines” infill pattern.

This is a remix of the QYo model by Shootquinn. I tried their model, but found the yoyo too light and lacking power. Added a lot more rim weight, and raised the response pad platform slightly to make the response a lot more consistent.
The yoyo now weighs about 60g (a little more with the axle + bearing).

Make sure to rotate the model so the rim is face down. 

Does not need to be printed with supports, if you are using Cura you can turn on the experimental bridge settings to make the bridging even better.