GVM Power Supply Pole Clamp

Designed to clamp onto the lowest section of the pole stand. Feed the cable through the bottom and connect, the power supply should fit snug with the feet going into the cutouts. Tilt the power supply away from the pole to remove. 

ADDITIONAL HARDWARE REQUIRED:
Minimum: 

• M3x40(should fit) machine screw x2
• M3 Hex nut x2

Recommended:

• M3x40 machine screw x4
• M3 Hex nut x4

I use M3x45 as I had more of them.

PRINT ORIENTATION:

Files not in print orientation, this is your choice. I do however suggest the curve is printed as a C shape (viewed from above) on the bed as large Z layer lines may cause fitment issues.