Allenkey/screwdriver holder

This is an allenkey holder I used when building my v0. Easy to put them back in and find the right one straight away. Avoiding them laying around on the desk.

Drawers for smaller stuff and some place to put screws or nuts. 

The bottom case needs some supports inside the holes (maybe if you've a really good printer it won't need them)

The tubes can be printed standing up as shown in the picture. You could also lay them flat and do some sanding This is a bit stronger but more work. 

The drawers will also need support.

To put it together first testfit all pieces. Make sure they fit and you know where the parts go. (The angled ends go to the bottom.)

Insert (with glue) the tubes and side supports into the base first. Then glue/insert the top part. (while the bottom is not dried yet)