Pinball The Big Leboswki Upper Flipper Bushing

This is a replacement bushing for the upper playfield flipper on The Big Lebowsi pinball machine. If you use PrusaSlicer, the .3mf should contain the variable layer height settings that I used.

While my printer is typically dimensionally accurate, in this case the modeled outer diameter was printing undersized. I had to model it about 0.2 mm larger in OD to get a good press fit into the playfield. I mention in case it prints too large on other printers.

The flipper shaft is contained and guided by three narrow rings to limit friction as can be seen in the cross section.

Print Settings

Printer Brand:

Prusa

Printer: 

I3 MK3S

Rafts:

No

Supports: 

No

Resolution:

varialbe

Filament:

- PLA+ 

Category: Toys & Games