Miele Dishwasher "Adapter" Part No 05640040

The story is that I broke this part in some friends dishwasher when I was over for the weekend. Had the model been available back then, I would have stood a chance to print it and leave their place with a fixed dishwasher. Since I had to order it by mail, I had to come back to their place later just to replace that 1.50 Euro part. If this happens to you, happy printing :)

Printing instructions:

• If you are concerned about stability, print with more infill.
• Due to the temperatures to be expected, PLA etc. are not good choices, PET/PETG was fine.
• I used “paint-on supports” in PrusaSlicer so that only the outer cantilever is supported but nothing else or else, I fear, it would create support in the middle, in the shaft “intake”.