VaseMode Tinker Tray

A Place to keep all your screws and allen keys when working on your printer.

Settings

Theses are the main settings to Change if your Using Simplify3D
These give me extra strengh in the print as the line width is 2x the size of the 0.4 nozzle.

Under Layers Tab

Infill 0%
Primary layer Height 0.2800
Top solid Layers 0
Bottom Solid Layers 3
Outline/Perimeter shells 1
And put a tick in the box for Single Outline Corkscrew printing mode (Vase Mode)
First Layer Height 100%
First Layer Width 100%
First Layer Speed 50%

Extruder Settings

Extrusion Multiplier Set to 1.10 (This compensates for the extra line width.)
Extrusion Width 0.80mm ( Extrudes 2x the 0.4mm nozzle width.)

Speeds

Default Print Speed 60.0mm/s
Outline Underspeed 50%

Speed Overrides Setting

Ticked Adjust printing speed for layers below 15.0 sec
Allow Speed reduction down to 70%