Tonie figure holder for IKEA Skadis V1

Holder for the magnetic figures of the Tonies-Brand.

Inside the Holder, there is a 35x2mm cutout for a steel disc so the figures will stick to the holder. The double-holder (with 2 discs) fits for the bigger tonies like the ones from Disneys “Cars”

Fits the slots of IKEA Skadis and Uppspel pegboards. On a 56x56cm board you can place about 36 of the single holders which stores about 72 Tonie figures.

Materials:

• PLA or PETG in the colour of your choice
• Steel disc 35x2mm
  • I used these from supermagnete.ch and they deliver in most of europe.
  • Users have reported success in using 30mm washers (see comment section)

Printing:

• Use the “filament change” or “pause” function to stop the print to place the disc, then print over it
• adjust number of walls for the hook-part to make it filled completely with walls

Miscellaneous

Support

If you like this printable and want to support future projects, you can contribute to my next roll of filament on Ko-Fi. https://ko-fi.com/smallthings_ch