Airtag keychain

 The one in the photo is printed with CF PET-G from Prusa. 

When printed, just snap in the Airtag and its held snugly. 

Best printed with a 5mm brim with the flat top facing the print bed. When placed like this it doesn't require supports. 

Support and Feedback:

If you like the design, you can buy me a coffee here: https://www.buymeacoffee.com/kazikg

Encountered any issues or have suggestions? Feel free to leave a comment below. I'm here to assist and continuously improve this design. Your feedback is invaluable! :)