Phone Stand

A modern twist to a device stands with an engineering support method. It incorporates a triangle pattern for the back structure and an indented storage section at the base.

As the model is designed to have a floating effect, the model does require support. The model was printed with the ESUN Magic green and blue filament with the brass nozzle at 230 degrees. 

Dimensions

Width: 70mm

Height: 120mm

Depth: 100mm

Viewing Angle: 50 Degrees 

PRINT INSTRUCTIONS

Can be printed horizontally or vertically, depending on preference. The model was printed on the side as shown in the pictures below 

Printer File No.:1× print file

Support: Internal  Support between curves

First Layer: BED 70 Degrees. Nozzle: 230 Degrees

All other Layers: Bed 60 degrees. Nozzle: 215 degrees

INFILL: 15%