Bucket Filament Holder / DryBox

Simple dry filament spool holder I made with a olive/paint bucket or any other plastic bucket (and corresponding lid). To change spools, put the bucket upright and remove lid, then close it again and place it sideways.

Dimensions:

• Rod/Spool holder bar diameter: 13mm (+0.8mm offset; actual diameter: 13.8mm)
  • This is the diameter of the broom stick or rod that fits in the printed part shown in the 2nd picture.
• "Bowden" tube outer diameter: 7mm
  • This is the outer diameter of the black HDPE garden watering pipe/hose that guides the filament once it leaves the dry box.

Print as you know best ;-)

Files require re-orientation/positioning (done in slicer-» rotate model)

Category: 3D Printer Accessories