Shelf and covers holder for Hadley

Another little project to soak up some leftover screws.

If you have installed the Hadley rocker stiffener mod by Tom Avisar, you now have half a dozen conveniently placed horizontal beams that just scream “hang something on me”

Here you have a base bracket held in place via 2x M4 nuts and M4x20 screws (to be honest mine snapped on the 12 mm pipes just fine and would stay there even without screws, but better safe than sorry).

On the bracket you can use M4 hardware again to mount a little shelf, or a holder for the cover caps (in this case you also need to add the spacer in between, or it conflicts with the stiffener joints)

Both holder and shelf print just fine upright, without supports,.

For the bracket I tried face down with supports in the U bend, but they are a pain to remove and any residue compromises the fit. It is better to print it on the side with a generous brim.