Low Profile Filament Guide for Neptune 3

I recently replaced the original dual gear extruder on my ELEGOO Neptune 3 for a single gear one optimized for TPU printing. 

Unfortunately, the extruder I installed was lower profile than the original dual gear extruder, so that meant the original filament guide wouldn’t guide properly. So I whipped this up in Tinkercad to solve this.

Print settings don’t really matter, since this a functional part and a simple one at that. You only need 2 M3x6 screws to secure it where the original one sat. 

Happy printing and guiding filament to your lower profile extruder!