Shower Hair Holder

Having too many drain clogs and finding hair on the shower wall, I decided to make this. It had an unintended perk that came in the form of a rough tip on top of the “spikes” to grab the hair better. So when that long hair comes out in the shower or bath, you can rub it over the spikes and it mostly pulls it off. Angled to keep water from accumulating. 

After printing it, I put a couple coats of clear spray on the whole print to make it easier to clean if needed and to seal up some of the crevices'. I used waterproof 3M Command Strips to mount it in the shower. 

Printed on an Ender 3 V2 with a .4 nozzle.