Nice design. Now I need to print a few more sets for MMU3
Prusa Spool MMU2 Holder Upgrade
I liked the ones from Thierry but wanted to save some space so two could with next each other on mu Ikea Lack wall…
37
161
4
1758
updated
December 6, 2020
Makes
Comments
I printed several of these and I am sorry I did. The tube that is filament sits on came out of the bearing several times. I thought this was my fault so I had to puss it back in several times. In the middle of a 10 hour print the tube came out again and I lost my print due to the filament being unable to spin freely. This kept happening on all the spool holders I put this print on.
Do not recommend. (edited)
@Solomon_36395 the tube is filament ? The tubs in the bearing are aluminium on my mmu.
It's so nice to finely have them side by side. Perfect solution. Thank You
Simple upgrade thank you