Anycubic Vyper EBB36 Bracket for Stealthburner W/Linear Rails

Since I am an absolute nutcase, I wanted to outfit my Anycubic Vyper to use a Stealthburner, Linear Rails, and of course, CAN. But after installing these parts, I realized that my print head wouldn't fit properly with the ebb36 installed. So, I remixed several designs here, to Frankenstein my own bracket. 

This bracket fits behind an LDO Nema14 stepper motor mounted to a Clockwork 2 extruder. It also has a shroud with a built-in PG7 mount for strain relief. When installed, this setup has plenty of clearance for the top mount MGN12H carriage, and enough space behind the print head to move across the X-gantry without issue. 

If you're using the EBB36, I'd recommend de-soldering the heater wire PCB terminal and flipping it around for a bit more clearance. 

This bracket is an amalgamation based on the following designs: 

https://www.printables.com/model/263868-bigtreetech-ebb36-stealthburner-mount-with-gland

https://www.printables.com/model/345860-ebb36-mount-for-stealthburnercw2-remix

Print Settings: 

• PETG (Though PLA and ABS/ASA will work) 
• No Supports
• 15-40% infill
• 0.2mm Layer Height
• Printed on the Anycubic Vyper