Charging phone holder for IMO Dash 4G

A simple charging holder for the IMO Dash 4G phone.

Prints in two halves. Print the top half with supports. Once printed, put the USB magnetic adapter into the bottom half and push the two halves together. You can glue them together but I find the pins do enough. If your clearances aren't great you may need to sand the pins a little.

Once constructed, put the magnetic micro USB adapter into the phone and push the phone and adapter into the holder. There will be some resistance as the adapter seats. When you pull out the phone it should leave the adapter behind, at which point you should be good to go.

Tip: use a USB A to C cable with this USB adapter; C to C seems to be a bit flaky when using the micro USB port adapter.

Requires:

• This USB adapter
• IMO Dash 4G phone

Print settings:

• No brim
• Tested with PLA
• 0.42 wall width
• Infill 30%