Bob-Omb Tissue Holder Improved

This is a remix of the Bob-Omb Tissue Holder I created in Fusion 360. I just increased the lip between the body parts for better friction and increased clearances between the locking parts.

Depending on your result the upper and lower body might not hold together strong enough to pull tissues out. I added some quickly designed interlocking parts, which you can just glue to the inside. That should hold everything in place.

Measurements: 17cm wide x 25 cm deep x 17 cm high

Printed on Anycubic Kobra using Anycubic and Overture PLA Filament

Print Settings

Rafts:

Yes

Supports: 

Only really needed for the eyes. Depending on your printer upper and lower body might also need a few supports to get the bowls started.

Resolution:

0.3

Infill: 

15%