CR-10 FANG W/ BLtouch (Micro Swiss Direct Drive)

EDIT 2/18/2020 Added wire guide to support clip (v3) If you have already printed this you can either drill a 3mm hole in the original base or just leave it. Seems stable enough without the extra screw

Fang mount for Micro Swiss Direct Drive

This base is for the micro swiss hot end

You will need to print the fan and 40mm fan duct from https://www.thingiverse.com/thing:2763931

I ended up needing t m3 nuts as spacers for the bltouch. I added a washer for good measure. All in all it is performing well

x_offset: -40

y_offset: -10

Print Settings

Printer Brand:

Creality

Printer:

CR-10S

Rafts:

Doesn't Matter

Supports:

No

Resolution:

.2

Infill:

30%

Filament: Overture PETG Orange