Monoprice Select V2 / Wanhao Duplicator i3 Printer Enclosure Backdoor

I built an enclosure out of an upcycled table and cut out a hole in the back for cables. I then modified the UK variant of a "Brush Faceplate" for low voltage cabling - single gang. I cut off the bottom and created this bracket to properly hold it in place. Works great for cable management!

Uses M4 bolt and nuts, also used some all-purpose silicon to help seal things up.

Print Settings

Printer:

Maker Select V2

Rafts:

Supports:

Doesn't Matter

Resolution:

Infill:

5%

Category: 3D Printer Accessories