3D Printer Electronics Enclosure (Pi, MOSFET, PSU, RAMPS, Relay)

This is a remix I made for some parts on the printer enclosure by obor.

I 'modified' the LCD Bottom part from ZhilDV to have holes so you can mount it on the enclosure's frontpanel.

I remixed it so it fits a 12864 RepRap Full Graphic Smart Controller.

You can basically put anything you want in there. It's pretty big.

I included 2 lower front panels.

• with 2 mounts for 30mm fans
• with no mounts but just some airflow holes (I use these with a 120mm fan inside the box)

I also included the original drawing files for if you want to lasercut the sides, top and bottom like I did. I used 2mm acrylic for this.