MICRO - A MICRO HANDHELD CR2032 CASE FOR ATTINY85 TINYJOYPAD

MICRO is a micro sized handheld cr2032 battery case for Tinyjoypad 

It's for the trimpot version of tiny-invaders.

The Arduino program, programming and building guides are in the zip files at Other Files section..

Since it's case for an old-school project, the built style is also old-school..

Check out the added simple guides and the info's for more information.

Not a beginner project, so be warned about the challenges:)

A good puzzle project for makers..

PARTS:

OLED Display 0.96 inch I2C 4pin White OLED Display Module 128X64 New version

trimpot PT10-1K ohm trimpot with hexagon header - trimmer potentiometer

Push Button 12mm x 12mm*5mm Tactile Tact Mini Push Button

Slide Switch 3Pin 2Position Black Mini Size SPDT Slide Switches On-Off

breakout board SOP8 SO8 SOIC8 TO DIP8 breakout board pcb Board Adapter

ATtiny85 Microcontroller Chip ATtiny85-20SU SMD 8-Bit 20MHz SOIC-8

2x "countersunk" 10mm M2 screws

Electronics consumables for makers

3D PRINTING SETTINGS

No supports are needed, No bed adhesion is needed unless you have bed adhesive issues in general

0.4mm nozzle, 0,2mm layer height, 20% infill

PLA+