SCALEPRINT LINKA COMPATIBLE DOUBLE SIDED BRICK TILE MOULD 00/HO

Today have something special for you Linka users a printed mould for making double sided brick tiles for those walls you want to see from both sides.

The mould has a 2 degree draft angle to help get the plaster part out of the mould.

I make the plaster like a paste then fill both halves of the mould and then clamp them together, giving a a number of taps on the bench so all the plaster flows together.

If you have a mould release it will help get the plaster part out of the mould.

When cured using a knife separate the 2 halves, and carefully working along the open end lift and remove the part from the second half.

This should also print on an FDM printer with a 0.2 nozzle as the mortar lines are 0.4 mm wide

Print Settings

Printer:

WANHOA D7

Resolution:

0.025 Z height

Notes:

I printed this mould on a Wanhoa D7 in Monocure Rapid Clear Resin which is a non-flexible resin as that is all that I have. If you have a flexible resin it would be easier.

This should also print on an FDM printer with a 0.2 nozzle as the mortar lines are 0.4 mm wide