Snug pen holder (vase mode)

Print in vase mode (cura: spiralise outer contour) make sure cooling is turned all the way to 100% so you can increase the printing speed. (around 100 mm/s) This way you can print this in like 20 minutes or so. Layer height 0.3mm

make sure you have around 8 - 10 bottom layers to keep the centre of gravity low. Also adds some rigidity

I printed mine in ASA-X because thats what material I had laying around, but I think any material will do

0.8mm nozzle or 0.6 nozzle for best results