EVA 3 PCB Klicky Mount (Volcano Hotend)

I couldn't find a mount for the PCB Klicky probe for the EVA 3 toolhead, so came up with this design. It borrows the toolhead mount point from other EVA 3-compliant probe mounts. 

You'll need M2 heat inserts (the ones that come with the PCB Klicky kit are the ones I used) for the 3 holes that secure the PCB to the print via the screw-in magnets. 

You can see in the attached pictures that when triggered, the mount leaves a bit of distance between the nozzle and bed. 

It's pretty close, but I haven't run into any issues with the nozzle running into the bed while calculating Z-tilt. If you do, you can use M3 washers between the probe body (the one that's picked up) and the magnets to give a little extra distance to the probe switch.

To print

place the entirely flat side on the bed, and print with supports.

offsets:
x_offset: -23.34
y_offset: -20.49

Happy printing!