Chicken Arms! - Chicken becomes Dinosaur

Chickens not included!

This is not original with me - just a print I made for someone from the file here :

https://www.thingiverse.com/thing:4614774

Print instructions

Print in PLA using the 3mf file provided; otherwise :

• 0.2mm layer height
• 0%
• perimeters = 3
• support on build plate only, contact Z = 0.2mm

I used olive green PLA.

Don't make the mistake I made initially of using variable layer height. I assume this would give a better quality print, but it created problems with the inverted parts of the print.

This really needs to be printed with the "hoop" section flat to the build plate (see photo) so that the filament layers will be properly aligned; there is really no good alternative to re-orienting the part for printing. Fortunately the "keep it simple" (with supports) approach works well.