Ring Doorbell Cover Plate

Ring Doorbell Cover Plate which fits battery doorbells 3, 3+, 4, and Doorbell Plus models. 

Fitment is designed based on the Doorbell Plus model however it will accommodate the models from generation 3. Models are designed with a cutout for the IR Illuminator light.  The model with “eyes” needs to be fit perfectly flush on your doorbell or it can produce a glare in night vision mode. 

You can decide the best material to use based on your climate however id recommend Nylon, Polycarbonate, PTEG, or ASA for use outdoors. 

All models are designed to be printed face down on build plate without supports assuming you have your bridging settings tuned however you can use a small support for the bridged areas. 

Lastly, fitment is tight but spot on for a press on fit.. fitment may vary with your printer. That said, you can upscale it 0.25 - 0.50% for a loser fit and tune it in with  electrical tape.  

Photo Examples were printed in black Sunlu PLA+ using a P-Flat gradient sheet for a print bed.