Remote Holder, Cord Wrap, and Cord Clip for DeLonghi Space Heater

This is a remote holder, cord wrap, and cord clip for the DeLonghi HFX65V15L Space Heater.

WARNING: This is intended to be used during storage of the unit ONLY. I do not recommend using the unit with these attachments on it.

The holder has 1 set of clips and the cord wrap has two sets of clips that clip into the back grill/intake of the space heater. Each set of clips clips into an individual hole so that the outside of the set of clips is pressing snugly against the inside edges of a single hole in the grill. This means you will use one hole only to clip the remote holder and 1 hole for each set of clips on the cord wrap.

The cord clip attaches to the cord immediately below the plug and clips onto a portion of the cord next to the plug once it is wrapped up.

Notes:

I recommend printing this with about 5% - 10% infill with supports as necessary.

I printed the remote holder standing up and supports were only necessary for the clips.

I printed the cord wrap on its side and supports were only necessary for clips and the arms.

The cord clip can be printed with no supports.