VCore 3.1 Bed Arms with Heat Inserts and Logos

Because I don't like the hex nuts and I like clean look of the bed arms, I remixed the original RatRig VCore 3.1 bed arms and added heat inserts.

On some (rear arm + right arm) I also added RatRig logos.

On the rear arm you need to replace the original M3x35 screws that hold the cable relief with M3x10.

For all three arms you need 8 pieces of M3 brass heat inserts.

I'm not gonna ask for a coffee, but please make sure you give me a like if you find this model useful.