EDC Tape and Cord Storage Dispenser Keychain

With this print you will have approximately 8 ¼" (30cm) of 1" (2.5cm) gorilla tape and 16" (40.50cm) of microcord at the ready. You can even store sewing thread instead of microcord.

The storage dispenser can be attached using 325 cord or paracord. When using paracord you may need to remove some of the inter strings. 

Print in your choice of filament but PETG is recommended. For MK3 users just print the gcode for the best results or use these recommended print settings:

• 4 perimeters
• 0.20 layer height
• 100% infill
• Painted supports to cover the first two overhangs. Do not support the top hole as it will be used to thread in cord to attach the dispenser.

Created in tinkercad.