Remixed - PwnCNC Dust Boot - Vinyl Cutter

Remixed the PwnCNC Dust Shoe to hold Amazon Vinyl Cutter.

If using the Makita router you'll also need this if you do not already have it: https://cdn.thingiverse.com/assets/a7/76/bf/03/f6/Collar-65a.stl

This is the one I used from Amazon. https://www.amazon.com/gp/product/B0794T4Q9Y

I sourced a spring from my local Ace Hardware

I used M3 brass inserts and M3 bolts on the back just like you would for the dust shoe itself.

Printed upside down at layer height of .24 and 35% infull - full supports

Be careful not to forget the cutter is there and get your hand anywhere near it... sure not a table saw accident but they are sharp and does not take much to cut your hand up.

Print Settings

Rafts:

No

Supports:

No

Resolution:

200

Infill:

20

Filament: PolyMaker PLA