This is a remix of "Topology optimized shelf bracket".
92
885
3
4205
updated August 1, 2019

Makes

Comments

Really classes up a basic cedar board. Great design!

Quite powerful. I added two holes for M4 screws to fix the boards. The lower boards have three supports. The top one only two. They hold these shelves now for two years.

Printed OK but I went a bit too fast, so the top layer is a bit of a mess and adhesion isn't great. Nice design. Orientation means the layer adhesion won't hurt me too bad, but I'm keeping this one for light duty.

Printed it standing up, diagonal on the printbed and managed to print two at the same time.

What did you print with filament wise and what infill %. Cheers

Works great, I was able to hang from it as a test lol

All comments loaded