Ryobi Area Light Lantern Handle

So I bought this Ryobi area light, and on the top, there is just a hook with no real good way to hold or carry it. So I designed a handle to replace the hook.

There's a 2mm diameter pin holding the hook onto the lantern. Pop it out with a small punch and hammer. A nail may work well too. Save the pin. The new handle will install the same way.

Make sure to print with supports.

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

Doesn't Matter

Supports:

Resolution:

0.2

Infill:

Notes:

Enable supports.