This is a hex key holder for the Wanhao Duplicator i3 v2.1.
I needed a place to hold my hex keys, and I noticed a couple of small holes on the side of the gantry (probably for putting a z-switch on), so I designed this little part to go there. It fits quite snugly and holds the keys very well.
The v2.1 comes with these holes, other versions might not. Check before printing.
Printer:
Wanhao i3 Duplicator
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
0.3
Infill:
15%
I used OnShape to design this (as I run Linux and none of the "professional" tools will run). Feel free to remix it:
Category: 3D Printer AccessoriesThe author marked this model as their own original creation. Imported from Thingiverse.