MKS Wifi case for 2020 mount

This a case for MKS Wifi, a serial<->wifi module based on HLK-RM04, allowing some 3DPrinter controller board to be wireless.

This case have to support to mount it on a standard 2020 aluminum profile. It's design to largely protube from the 2020 profile, so that the antenna is free from obstacle.

It has a small hole for the antenna, and another one to access the reset button.

The top part may be a bit trickier to print than the bottom.

It uses standard M3x10 screws: 4 to close the box and fix the board at the same time, and 2 + T-nuts to fix it to the 2020 profile.