Alien beer mug / glass

This is just a mug / glass for beer, it has some wired organic shapes around it and some runes to make it look out of an alien world. 

Print out of PETG ideally, but PLA also works. The main reason you should print it out of petg is so that it can hold liquids properly. It's also easy to clean and really sturdy. 

Ideally, it should be sliced in Prusa slicer 2.6 with organics supports on buildplate only and 0.2 mm layer height, this was printed on an Ender 3 v2 with the sprite extruder. but regular supports also work, but they should be set to everywhere for best results. Primarily to support the handle. The rest of the model doesn't need support, you can paint on the supports on the handle and it will work well. Adaptive layer height may significantly reduce the print time (not tested). it takes around 17 hours to print at 60 mm/s.