Prusa Mini+ Power Supply Holder

A Power Supply Holder which is mounted on the back of the Prusa Mini+ with the 4 screws on the injection moulded part. 

How to assemble it:

You just print all 3 parts (the two holders and the door) and then you have to screw the “door” with a short M3x12 screw and a M3 square nut. The hinge of the door is a M3x30 screw.

You screw the two power supply holders on the back to the injection moulded part of the prusa mini with these 4 big screws on the printer.

This makes the power supply a part of the printer.

IMPORTANT:

Make sure that your Printer stays squared, when you tighten the screws: https://help.prusa3d.com/article/squaring-your-mini_158518