Umbrella Stroller Handle Extension

I have found that the handles on my daughters umbrella stoller were just a bit too short to be comfortable so I made extensions. I originally planned on using 1/2" pvc for the handles so the clamp is sized to allow that. However since I am using a cr-10 I was able to print handles that were long enough. I have been using the handles the last couple of days while on vacation and will probably be making a few changes from things I noticed but mainly just the handle design not the clamps.

Print Settings

Printer Brand:

Creality

Printer:

CR-10

Rafts:

Yes

Supports:

No

Resolution:

.2

Infill:

30

Notes:

I printed the clamps vertically and the handles on their side with rafts and sunk 2 mm into print bed. I also printed everything in PETG with 3 shells. I would think that the would be a little less flexible with PLA for the handles but I did not want to worry about them breaking.