Gameboy Advance SP Pokeball Themed Case v1.1

Introducing the PokeBall Case for your Gameboy Advance SP!

If you are really into Pokemon games and happen to have a Gameboy why not give this a print. I modeled this around a Gameboy model which is of proper scale. There are 0.3mm spaces in between printed parts allowing for good fitment.

Update v1.1 

- Updated L&R_trigger to L&R_trigger_v1.1 (fixes gap between bumper and the trigger part itself.

- Updated misaligned holes in the case_bottom

- Updated fitment for both case_top and case_bottom

- Closed a gap in black_ring which caused parts not fitting correctly.

- Closed a gap for the button_connector piece

Assembly:

Parts List:

• 1x case_bottom
• 1x case_top
• 2x L&R_trigger
• 1x white_button
• 1x black_ring
• 1x button connector

To assemble this model, please reference the pictures as best as possible. To assist with this let me explain. Both triggers are intended to be loose fitting until your Gameboy is inserted. These were made to relocate the triggers to the outside of the case. As for the button section, simple start with the black ring on the case_top and then place the button with the peg in the hole of the top_case. Then secure the button with the connector on the back. All that is left is to insert your Gameboy and enjoy!

Print Settings:

• Print all files in orientation provided (each file is already placed how it should be on the build plate.
• 0.2mm layer height
• 0.4mm nozzle
• Supports needed for case top/bottom only
• Infill is your preference
• Bottom case is recommended to have a layer pause at the point where white turns to black. This can be done in your slicer.

*Note - This model has not yet been tested, however it is in a state where everything should fit nicely and is printable in general. Would appreciate any testers/suggestions to fix any issues!